Michael Sherve
Comments
-
Have you tried to use the vector doctor? It will give you an indication of where the troubles are, you might just have a small section that's the problem child. When you find out where it is you'l...
-
Out of curiosity, in Carveco Maker, can you transform your vectors? Using the Transform tool? Looking at the Vector tools (sorry, I have all the icons on the side fly-outs) it'll be the third one d...
-
Hi Robert Brodman, When you made the toolpath, did you notice where you get to select the bit you have an option to describe the thickness of your material? It's way down on the bottom and it needs...
-
David, I tried a bunch of texts and I haven't been able to do that, I've had a few that didn't please me but there hasn't been one that has automatically changed it's size, in the lower right of...
-
Mind if I ask some questions? Like in the software when you went to do the toolpath, did you specify the material thickness (sometimes when I get too busy this happens to me), are you zeroing o...
-
Have you thought about doing a profile first then the other toolpath, I don't have the latest version but if I remember correctly you can add a ramp to it, the ramp will do a slow cut at an angle t...
-
Not wanting to be a butt head but your request seems a little odd. What year did Artcam come out into the market? What year did Vcarve enter, same? Ever noticed that the lay-out of both software's ...
-
Didn't Thermwood have that like 20 years ago in their software, I think they did, but their software was cabinet driven, 2D, "X", "Y", in setting up the job you told the software you were cutting ....
-
Ok, my tolerance is .001 I also rotated the file and ran it again it gave the same results, I'd like to point out that I have 4 nodes, your 7 isn't too bad, I did mine at a .0247 step over with the...
-
You mean by just using the toolpath you could change the "Z" height because you purchased a 3/4 inch board instead of a 4/4 board? Mike