Michael Sherve
Comments
-
Every image is different, and each one from my experience require thought, some don't require much work, some blow the mind with the complexity, some you can do in an hour,or less, some take days a...
-
Have you touched off on your "Z" zero plate? so your router knows where the top of your material is, or the top of your bed (this is dependent on where you in your toolpath you set,your "Z" either ...
-
Zowie, that is sure cool Michael, talk about an imagination on overtime, nice, nice, nice!!! mike
-
Nice, is this going to both white and yellow gold, or will it be silver? Cool design. mike
-
Is there a difference between them (toolpaths) when you look the tolerance? This could be the place to look.I keep mine at .0001, might be a little snug but it works for me. mike
-
Take a look at a toolpath choose a bit size you will see that you can edit your feed and speed rate for any bit you choose then when you run the toolpath it will run at a different speed. Might I a...
-
Vance, sorry didn't mean to be snarky you can edit the feeds and speeds for the toolpaths in bit selection here's a photo of a quarter inch ball end. mike
-
Odd, my toolpaths in carveco do??? Where are you getting your info? not only this but the router I use also in the control software the ability to over ride suggested speeds and feeds, so if you ...
-
Leighton, What I suggested was for future usage of stl files, I have a lot of them and I have found it's easier to find and bring in clip-art then it is to remember the name of the stl where in c...
-
Tried something new and it worked, esp with my grandchildren I sent out over 200 of these to them, mom and dad said uhh dad their rooms are not big enough............ Oh well. Thanks