Z issue trying to cut air
HI all I have an issue where I make the toolpath on here for 3d toolpath, then when I go to carve it out either in Easel or UGS, it goes up in the Z axis and cuts air. I'm not sure where I am going wrong in my settings.
Also the picture I am trying to carve out is so very faint in depth it's hard to define, how can I adjust my settings to make it deeper of a cut of our dog's face?
Kurt
Comments
Have you touched off on your "Z" zero plate? so your router knows where the top of your material is, or the top of your bed (this is dependent on where you in your toolpath you set,your "Z" either top of material or bed of the router)
mike
Please sign in to leave a comment.