Michael Sherve
Activity overview
Latest activity by Michael Sherve-
Michael Sherve commented, I'm with Brady on this one and I only use Carveco, There have been times I get overly frustrated with all the steps I have to take to make things, some of those steps add a lot of time, they could ...
-
Michael Sherve commented, Did you paste the baby down?? mike
-
Michael Sherve commented, Noob, How about getting the diameter of an example (one bit) pasting it here, it isn't really hard to bring in bits so you can add them to your library of bits to use., I will give you step by s...
-
Michael Sherve commented, That is very pretty Michael. What software are you using? mike
-
Michael Sherve commented, I have done this when I have different models to cut out and I don't want to turn on the vacuum or or I'm running on both ends of the board and nothing in the middle or I want to be careful about b...
-
Michael Sherve commented, Ollie, I understand, I do wish when the toolpaths run they would take the most economical moves, but they don't seem to, like when I run a 3d it goes to the furthest point away (really?? is my q...
-
Michael Sherve commented, Ollie, Try grabbing the first (top) ones run a toolpath, next do the same with the second (middle) group then do the same with the last (bottom) group. Now when you go to save the toolpaths combi...
-
Michael Sherve commented, Not the star the box next to the star
-
Michael Sherve commented, Hey Robert, You have an icon (a star) next to that is a blue box with red underneath try clicking that (I never touch those thing, so you might have) that one ICON shuts your 3d off.(I think it'...
-
Michael Sherve commented, I don't own a laser, but I would imagine you would not because there would be no friction caused by an end mill. I am coming from what I use in my shop I would run a ball end for indexing and place...