Kurt Windfeldt

Total activity 2
Last activity 23 April 2020 16:56
Member since 23 April 2020 16:56

Following 0 users
Followed by 0 users
Votes 0
Subscriptions 1

Kurt Windfeldt created a post, 23 April 2020 16:56
Z issue trying to cut air
1. Community
2. Community Feedback
HI all I have an issue where I make the toolpath on here for 3d toolpath, then when I go to carve it out either in Easel or UGS, it goes up in the Z axis and cuts air. I'm not sure where I am going...
- 2 followers
- 1 comment
- 0 votes