Elina Panagakou
Freelance designer - 2D and Bas relief models on request. Based in Greece, collaborating worldwide.
Comments
-
Hi Guillermo, I understand what you're saying... However, it's quite clear that nesting doesn't work with open vectors. So, since you really need to keep these open vectors, then I'd suggest to fol...
-
Hi Guillermo, I'm not an expert regarding toolpaths... but this info might help! When the window is open, click the little question mark on the top right, and all info will be displayed. Then, if y...
-
Hi James, Firstly, make sure that the right vectors belong to the right layers (in case they're all still in Default) but I assume this is not the issue.. As you said, and it's true, when a layer i...
-
Hi Mark, There is nothing wrong with your design. Every green mark shows where the vectors intersect with each other. It makes sense that they cannot be joined as one continuous closed vector. In c...
-
Okey, I see!! Now I get it... many thanks for these mike!
-
Hi Mike, just out of curiosity.. could you share the initial pictures that were converted to a relief? To be honest, I haven't experimented with AI at all (yes.. still thinking about it)! That's wh...
-
Hi Laurence, It's true Vector Doctor is a bit sensitive. Next time, try changing the Tolerance. Regarding the Fillet tool, it only works on straight lines and arcs, not polylines. What you need to ...
-
Hi Michael, Thank you for your comment.. I admire your knowledge on the software, so it's my pleasure to receive this positive feedback from you :) Elina.
-
Hello Zack, Unfortunately, not any grayscale image works perfectly with Carveco.. The image you turned into grayscale will not work properly, because the 'grays' refer to the shadows and not the d...
-
Exactly. DXF will do the work! hope you don't have too many layers to export again.. :)