Zachariah Collom
Posts
-
Inlay help
I am trying to get my inlays to work. I am using text. For a v-bit I am using a 1/32 12* ball nose bit entered as a v-bit. For clearance I am using a 1/8 followed by a 1/16 end mill. Using the same...
-
2 sided 3D carve tutorial
I am looking for a tutorial for 2 sided 3D carving setup in Carveco. So far I have only been able to find them for other software. I would like to import a large spoon design (.stl) and carve each ...
-
Answered
how to figure out what g-code line part of your carve is at
I created a carve in Maker, and moved it to my Onefinity running Masso. about 1.5 hours in it stopped and would not recover. I was not able to see what g-code line it was at. Is there a way in Carv...
-
Answered
Having difficulty joining vectors - single line closed vectors
(please also see all added comments below) I imported my design from a dfx. I created the vector, made sure there were no duplicates. I then went to create the tool paths and I of course got many e...
-
Answered
How to fix vectors that are too close and or cross each other
I have imported a bitmap into Carveco Maker, used the Bitmap to Vector tool. I tried using the Vector Doctor tool. I went through and deleted all the small vectors that are created. But the problem...
-
Answered
Can't fillet after offsetting
I just got Carveco Maker, and am trying to set up a few projects to carve. I have a triangle that is 22" by 15" will filleted tips. I offset this inwards by 1.9" The offset is a triangle with sharp...