Zachariah Collom
Activity overview
Latest activity by Zachariah Collom-
Zachariah Collom commented, I am using Kunstler scrip: https://fontzone.net/font-details/kunstler-script The name I am trying is Higbee, I have done some vector work with all the intersections. I am carving it in Maple end gr...
-
Zachariah Collom commented, I have tried it with a 30 degree v-bit, but the problem is that it does not get deep enough on the female cut, and then over cuts the male so there is not enough to fill the thinner female cuts. I ...
-
Zachariah Collom created a post, Inlay help
I am trying to get my inlays to work. I am using text. For a v-bit I am using a 1/32 12* ball nose bit entered as a v-bit. For clearance I am using a 1/8 followed by a 1/16 end mill. Using the same...
-
Zachariah Collom created a post, 2 sided 3D carve tutorial
I am looking for a tutorial for 2 sided 3D carving setup in Carveco. So far I have only been able to find them for other software. I would like to import a large spoon design (.stl) and carve each ...
-
Zachariah Collom created a post, Answeredhow to figure out what g-code line part of your carve is at
I created a carve in Maker, and moved it to my Onefinity running Masso. about 1.5 hours in it stopped and would not recover. I was not able to see what g-code line it was at. Is there a way in Carv...
-
Zachariah Collom commented, Mike, I apricate the help. Unfortunately I am not following. I am using the node editor, have the vector highlighted, hovering over the node and nothing happens when I press any letters on my keybo...
-
Zachariah Collom commented, mike, Thank you for responding. In node editor, if I press "R" I get the relief drop down, as with "I" I get the view drop down. I have been working in node editor and as far as I can tell the node...
-
Zachariah Collom commented, Ok, I tried using the node editor and I found that I have closed shapes. I pulled the green node in the middle down and created this shape: I don't want the lower part, but if I use the trim tool ...
-
Zachariah Collom commented, Basically I want to join these vectors and don't know why I can't. When using the vector doctor i get this: I can't figure out how to fix these intersections. Thank you
-
Zachariah Collom created a post, AnsweredHaving difficulty joining vectors - single line closed vectors
(please also see all added comments below) I imported my design from a dfx. I created the vector, made sure there were no duplicates. I then went to create the tool paths and I of course got many e...