Michael Sherve

1. Community
2. Maker & Maker+ Support
3. Saving Millright Inch toolpath

Ron,    I save my toolpaths to a folder then transfer it (or them) to a jump drive then bring it (or them) to my router out in my shop.    mike

• View comment
• Created 13 February 2021 15:35
• -1 votes

1. Community
2. General Discussion
3. deleting files

Mike,    Do you mean from the stuff that shows when you first open up Carveco? The stuff you or someone else was working on???    If this was what you're talking of, one big easy is to make a new f...

• View comment
• Created 02 February 2021 03:14
• -1 votes

1. Community
2. Feature Discussion
3. Faster , more accurate Undo & Redo

Elyasaf, A work around for me has been to duplicate the layer then use the copy to do your design changes on, I know there is many problems with this way but it works for the problem at hand. I kno...

• View comment
• Created 21 August 2019 17:31
• -1 votes

1. Community
2. Engraving Talk
3. turning a simple bitmap into a nice 3d form demo

I forgot to add that I import my photos, with this one I got some nice vectors, though I like clean lines so I deleted most of the nodes, then went from there. the last photo (the bottom pic) was w...

• View comment
• Created 02 August 2019 02:25
• -1 votes