Michael Sherve
Comments
-
Have you given it a try yet? Don't forget the oval should only be about a thousandth of an inch thick and as long as you need the slot to be. Remember the start point has to be where you want the s...
-
Are you talking of the toolpath? In choosing a toolpath you set the material "Z" either to the top of the material or to the bottom. You might want to check how the toolpath is setup. I am hoping I...
-
Cool, glad to be of assistance. Have a good one. mike
-
Ok just for your info I haven't got carveco installed on my pc (I'm waiting till I get a newer one then I'll be installing it on that) this pic is of artcam 2018). What you'll want to do is get all...
-
I think the shaft on those things are like a quarter inch right? I would make a very small oval then use the profile toolpath (start node (the green booger) on where you want to start the plunge, r...
-
I forgot to add the photo, sorry about that.
-
That's really cool the way wood responds to being milled, huh? What type of material (wood)? With the 1/16 inch bit you can get by dropping the thing down by .03". I would change the height touch-...
-
Yes, you can switch at anytime you start a new model, just specify, it gives you the choice. If you wish to switch in mid-model then look at "set model size" that would be in the second group on (o...
-
By the way what toolpath have you run?
-
You talking of using the vector dr.? I, myself seldom use that if I do I go as far in (magnify the node and area) to see what's causing it, could be a vector that's not connected (you have 2 instea...