Michael Sherve
Comments
-
Alex, If you don't mind what's the font, I want to give it a try too. Size would be great also. Usually if I'm going to give some angled cuts I'd use the the v-bit toolpath or in my case I'd al...
-
What toolpath did you use? mike
-
You selected drill on selected layers. I had a sheet the other day that had 20 mm holes, 8 mm holes and 12 mm holes, I used a 1/4 inch bit and a profile toolpath (didn't have those sized bits) ev...
-
Rob, Depends on what you are doing. For the most part since I cut wood and plastic, very seldom anything else I stopped doing the roughing (I'd still do it on aluminum) I just change the size...
-
Jim, Have you tried to contact support directly, they are great people if there is a problem with the software they should know so they can fix it, if it's a problem with your computer they can...
-
Chuck, It all depends on what you want to do. If you want to do round you do it just like you would do on a lathe, same if it's off center. mike
-
Collin, It just might be the font. Which one did you choose? Choose a different one, there are fonts that go from right to left and some that tend to go up and down and some that are just squirr...
-
Zachariah, That is a beautiful font, it does need some fixing, but I don't think I'd be using it much. When I put the "H" on to a 9.5 by 15 inch modeling area, there was quite a bit to be concerne...
-
Zachariah, Do you mind giving me the fonts and possibly the text, I would love to give a try. Right now my router is rather busy, but I would really like to give a charge at it. I have a pr...
-
Zachariah, Have you tried to sand the bottom of the male part? There are reasons for a "V-bit" it gives you the right clearance, just encase there are variations in your "Z" or the wood, try usi...