Michael Thornburg
Finally stepped into the world of CNC. Both of my boys are engineering majors and they seem interested. As for me I think Its a good fit for their education. Long time wood worker but have always liked Technology.
Activity overview
Latest activity by Michael Thornburg-
Michael Thornburg commented, Are those libraries ever added to or updated and how would an end user know.
-
Michael Thornburg commented, Thanks for sharing the/a solution.
-
Michael Thornburg commented, So, two issues... 1: I did try the 4 and 5 decimal places and from my notes that did not work. 2: Try as I might, I cannot get the error to trigger. I have loaded old cut files and run them all and...
-
Michael Thornburg commented, Sorry I must have missed that. I know I found references online on how to extend the support to 4 places, I feel like I made those changes on my own with no success. But I will take a look again at...
-
Michael Thornburg commented, Sorry time is a fleeting thing. So the post processor I was given the only change I could see was the addition of the G90 line. This fixed a different issue but did nothing for the 33 error. I tho...
-
Michael Thornburg commented, CarveCo support This was escalated and then combined with an unrelated error. So never really addressed. Covid and life in general had tabled this issue until Victor brought it back from the close...
-
Michael Thornburg commented, Victor I know I switched all the holes I was milling to drilled holes. I used some old router bits for the plunges. The error had to do with holes in my replacement waste board. All the mounting ...
-
Michael Thornburg commented, The controller will work without a card. But yes, to run files you need the card. I have not had any issues with the latest post processors. I work in mm in cast that matters.
-
Michael Thornburg commented, Thanks
-
Michael Thornburg commented, This issue has popped back up again... I have been running (trying) files to cut holes for an added waste board. I tried cutting 9mm and 10mm holes with a 1/8 bit but I was getting Error 33 trouble...