Michael Sherve
Comments
-
David, What is the result you're looking for? It might be real helpful for someone willing to help if they knew that. mike
-
Lori, I think I answered your question on the previous post. But just a question (if you don't mind) Have you tried to mill, or run a toolpath on a model size of 5.5 by 5.5 inches and do the whole ...
-
What do your vectors look like, I assume you are toolpathing inside of the vectors? What happens if you were to make a new vector, with the fewer nodes, would it do the same thing? I have said many...
-
You try two different toolpaths, one cutting convectional, the other climb? (This in just your toolpath menu) In your options menu you can change the direction of the toolpath, seems like a lot of ...
-
Have you given it a try yet? Don't forget the oval should only be about a thousandth of an inch thick and as long as you need the slot to be. Remember the start point has to be where you want the s...
-
Are you talking of the toolpath? In choosing a toolpath you set the material "Z" either to the top of the material or to the bottom. You might want to check how the toolpath is setup. I am hoping I...
-
Cool, glad to be of assistance. Have a good one. mike
-
Ok just for your info I haven't got carveco installed on my pc (I'm waiting till I get a newer one then I'll be installing it on that) this pic is of artcam 2018). What you'll want to do is get all...
-
I think the shaft on those things are like a quarter inch right? I would make a very small oval then use the profile toolpath (start node (the green booger) on where you want to start the plunge, r...
-
I forgot to add the photo, sorry about that.