Michael Sherve
Comments
-
Lonnie, How about a work around? I usually run 2 finish toolpaths when cutting out raised reliefs, like a 1/4 ball end then a 1/8 ball end or a 1/16, it all depends on if I'd snap the 1/16. ...
-
No problem Mark. Hope it's what you needed to know. mike
-
When you bring in a file you have some choices to make, one of those is "Z" height, ,or rather range you can add to that or you can have the software do it for you automatically you just have to ha...
-
Dan, Is this a program that you install on your computer or is it one of those things you have to be online? mike
-
Just a few questions (this is sort of real general and vague) I don't know if you downloaded them, if you did what format did you get, you must have brought them into Carveco, if you didn't you wou...
-
Have you tried to mill between vectors yet? (Inside) You have an area that you do not want cut make another vector for that area, rerun the toolpath so it cuts inside the vectors, here are 4 photos...
-
Elina, Thanks for being eloquent. I know what I need to do in Carveco, mainly because that is the only thing I concentrate on, your view point was spot on. Again thank you. mike
-
The only other way would be for someone else uninstall the software for you I believe. I think you'll have to wait till Monday, which kind of sucks. This isn't like when we had a dongle (a plug in ...
-
https://carveco.com/faq/how-can-i-deactivate-my-software/ mike
-
Also I wanted to point out that Photo Shop I believe is the only program that I know of that can really give a good gray scale image I don't think CorelDraw can really do that, in truth I have phot...