Barry Goodman

1. Community
2. Maker & Maker+ Support
3. Importing greyscale image to relief base thickness issue

OK Eric here are 2 base files, one 12X12 and 1one 24X24 inches. Please let me know when you get them in good order. All the best to you, Barry https://we.tl/t-1YpAi6T0hl  

• View comment
• Created 23 July 2021 22:41
• 1 vote

1. Community
2. General Discussion
3. zero position at 3D relief (newbie)

Roni, Mike is correct, if you set your mill to go below Z=0 you will be cutting into your table top. Perhaps you are familiar with another program but in Carveco Z=0 is the bottom of the model not ...

• View comment
• Edited 01 June 2021 03:12
• 1 vote

1. Community
2. General Discussion
3. HELLOOOOOOOOOOO!!!!!!!!!!!

Thanks for that, I had forgotten about you folks, always in the background and ready to help when needed. Thank you for all you do and thanks to the 3 folks who took the time to reply.

• View comment
• Created 22 May 2021 13:57
• 1 vote

1. Community
2. General Discussion
3. Hello, I am a new Carveco user... Running on a Mac in Parallels VM

Hi John, I think the discussion at the following link will help clarify this issue and its solution for you. The discussion may be found here,,,,,, https://support.carveco.com/hc/en-gb/community/po...

• View comment
• Edited 11 May 2021 03:58
• 1 vote

1. Licensing & Installation
2. Licensing
3. How do I migrate my Carveco software license to a different device?

Read the first post in this thread Evonne. It will tell you how to do this. All the best to you and yours.

• View comment
• Created 05 February 2021 16:00
• 1 vote

1. Community
2. Maker & Maker+ Support
3. tutorials

WOW, great post, well done.

• View comment
• Created 22 September 2020 02:57
• 1 vote

1. Community
2. Feature Discussion
3. Technique video page

Excellent job on the Carveco Fundamentals training course, thanks for it, much appreciated.

• View comment
• Created 17 March 2020 02:48
• 1 vote

1. Community
2. Jewellery Making Talk
3. Would be nice to see what you jewelers do

Rich, all of mine were milled in wax and then cast (at least the gold part was cast). Milling gold would not only be time consuming but also would be very wasteful, gold is expensive wax is cheap.

• View comment
• Created 18 February 2020 18:50
• 1 vote

1. Community
2. General Discussion
3. backups

Hi Evonne, If you still have your toolpaths (would be on the mills computer, possibly in the trash folder at this point) there used to be a tool that would convert toolpaths back to models availabl...

• View comment
• Edited 14 January 2020 15:03
• 1 vote

1. Community
2. General Discussion
3. Not sure where to start? Introduce yourself here...

Hi Jen, good to see you here,,,,

• View comment
• Created 12 August 2019 14:34
• 1 vote