Michael Sherve
Comments
-
That's awesome Barry. I'm too busy to be isolated. Just finished this, 80 inches long 17 inches high and .26 of an inch deep (this was a lot of work) mike
-
Just a little question, well maybe more...... Do you have the router yet? Are you prepared for the dust from that nasty crap you will be wanting to machine? Do you have the bits yet? Have you gotte...
-
I don't know anything of the mac or parallels, I've been using windows since 3.5, don't understand the need to run anything in an operating system that wasn't designed to run it, in my book it's li...
-
Have you tried to make a rectangle (real thin mind you) like .002" thick the toolpath will follow that in both directions, this is about all I know how to get it to travail in both directions. ...
-
Nice Michael, very nice, am very glad my wife didn't see this, I would be out some $$$. mike
-
In the menu bar go over to the word "relief" the last word on that page is "reset", giver er a try mike
-
I missed something like a ton of bricks falling on my head, Tony said "Multiple Z passes" I thought and thought on this and it just bugged the stuffing out of me, when I'm pushing the limit (most o...
-
You didn't say that you were cutting air, how high above the material is it doing this? I am going to assume that you touched off in "Z" for the ball end. When ever I run the 2 mine (the fi...
-
that finish tool (the ballend) will give you a real nice finish, that is the job of the finish pass, it may (as it should) go over the same area as the roughing toolpath, it does this to remove any...
-
Nice. mike