Michael Sherve
Comments
-
tapered ball end mills can cut shapes faster than a straight bit (end mill) because of the added material in the shaft, if you have a tapered ball with an 1/16 ball it will cut faster than a straig...
-
What do your vectors look like, What is your choice of a tolerance in your toolpaths, mine is .001?? Your bit is a tapered end mill not a v-bit. Mike
-
Oh and welcome. you can always reset the software also, you would have to do a search for how to do that on the forum, for me that would send me bonkers. mike
-
go to the top just as the black starts rt click it you will get your choices if you have the full version of carvecoMike
-
Eric, If you want to save the image of your model as a tiff, open the bitmap you will have at least one layer there highlight it below that you will see what looks like a floppy disk click that...
-
Steve, That is the font itself that lays the letters that way, chose another font. mike
-
I enjoy your statement Eric, we all do things like that even those who have had the software for 20 plus years, its always the simple things we just know after what it was we did so we don't have t...
-
Yea, the tree would have looked really good too, this mountain was so much work, didn't take into consideration what all would transpire in enlarging the model from a 1by6 to this size, didn't thin...
-
Roni, Does the above photo answer your question?? I imported your stl model in maker and ran the Machine relief toolpath down in the 3d toolpaths. so the answer is yes. mike
-