Michael Sherve
Comments
-
Hey John, Try the envelope distortion tool, hit the letter "T" that'll bring it up (should). then put the dimensions in that you want, what the offset is doing is .5 on all sides. If you want th...
-
Mark, I tried that and it still comes up on the left side. Like I said I don't use custom layouts but I did save the the thing as a custom but I still had to reload carveco then it would come ...
-
I Know I have a lapsed maintenance plan, I got too frustrated after putting in my request and it not being implemented I just could not continue, I just assumed it would not nor will ever happen so...
-
I don't use it but I do believe you can save your layout as a I think "custom layout" (?). To me it would just be too much to remember. I think it is under the window menu on the task bar. mike
-
Jonathon. You could as I have done set your "Z" zero to the top of material set the thickness of your touch pad thicker, touch the "Z" off then run the first finish toolpath, then after that one...
-
Do you mind if I ask "How are you holding the material down?" Wait a minute are you printing these bad boys? or are you cutting them out on a cnc? If it's cnc then my question is very valid. ...
-
Cool, Good luck. Mike
-
Jerrod, Have you been able to do this yet? mike
-
Mike, How large is your model? This will determine what bits you'll need to use. mike
-
Someone asked the same question on the artcam forum, so here's the answer again