Michael Sherve
Comments
-
Just a small question or two. What does your vector look like? How many nodes do you have? Is your vector squiggly? How big is your step over in the toolpath? If your vectors are 45 or so % to your...
-
Try running the "area clearance toolpath" this will clean the area out inside of the vectors, I don't use the flood fill just use the area clearance, does a good job. mike
-
Up in the menu bare (don't know if maker has this but) you have the word "model" you can open that go down to where you can "set size" if you click it you can reset the "origin" there you have 5 lo...
-
Out of curiosity, In the techno I use if I have the start point on my model wrong my machine goes the opposite way. for example if my starting point is in the upper left but I start my machine in t...
-
If I am reading right, Try to delete the simulation first then rerun your new edited toolpath. Me, myself I don't like to edit the toolpaths, I will change the vectors or the model then rerun the s...
-
The is in the menu bar "Vector" select and use export to a file you wish to use for select projects. I don't use "Maker" so I don't know the limitations to the software, but I believe you can impor...
-
Might I ask what variant of Carveco do you have? Do you have the full version, Maker or Maker+? Full, go here and watch the video: https://learn.carveco.com/3d-design-reliefs-and-models/importing-3...
-
When you run your toolpaths make sure the layer that you have open is highlighted if you don't it'll bring the highlighted layer into view. I don't think it'll run toolpaths on vectors that are not...
-
What font are you using? Some fonts are real squarely, They are absolutely strange, tried to increase the size of your picture and to my old eyes they just don't see it. Oh, you ever try to alien ...
-
You could start with the "start depth" set at .25, me though I'd do 2 toolpaths if I was using a compression bit, one) let that baby do it's thing then,two) again at full depth, or use a down cut s...