Carey Silk
Posts
-
Answered
Adding text to a curved surface in Z height to follow curve
Hi I am currently trying to curve my text item in the Z direction. I have the toolpath but it is level carving and I want to raise the text in the middle, so it follows a curve and has equal depth ...
-
Answered
Trying to do Bevel Carve but don't get Profile cut
Hi, I have been trying to follow Leighton's tutorial on the Bevel Carve operation. I have setup a text item, put in the bevel height of 4mm I want then the finish depth which is 9mm. I have selecte...
-
Answered
Simple sign tile
Hi, Hope someone can help. I have a 600 x 600mm cnc router and want to make a sign that is 1000mm x 250mm x 25mm in Maker Plus. It appears simple in Easel but I would like to stay with using my Car...
-
Answered
Zero Roundover bit
Hi What is the position of the bit for setting Zero for a 1/4" roundover cutter. Is this governend by the bit specification sizes?. Thank you
-
Answered
Unable to select text or any other component in the base of the relief
Hi I have a model that has a CarveCo frame relief and an imported 3D .STL with machining setup. Now I want to add text on the base of the carved out relief. The text went in but I am unable to sel...
-
Answered
Carving on Rear in #D
Hi am I able to set up a carving on the rear of my project by turning around the 3D position or do I need to create a new project and somehow tie the two together to carve.at the same time with tur...
-
Answered
Unable to do raster clearance
Hi, I am trying to do a raster levelling of a heart shaped vector down 4mm from 0. I have selected a 3mm end mill but I keep getting a "tolerance too small" error but I have tried changing all tole...
-
Answered
Carving comes out mirrored
Hi, I have saved a text carving out of Maker in both G-Code Arcs mm and UGS GRBL mm but when I go to carve in UGS the text comes out back to front (mirrored). The text shows up correctly in UGS sc...