Answered
Carving on Rear in #D
Hi am I able to set up a carving on the rear of my project by turning around the 3D position or do I need to create a new project and somehow tie the two together to carve.at the same time with turning the project over. I am trying to create a picture frame with an oval cutout and engravings on the face and also trying to carve out the rear for the glass and photo rebate.
Thanks
Comments
Hi Carey Silk,
You would need to flip your piece and then create and run a toolpath representing the opposite side of the design. When doing so, you would need to make use of a method to accurately line-up the piece. For example, using dowels and a cut depth into the wasteboard to secure them in place.
Thanks for your time and consideration.
Please sign in to leave a comment.