Zachariah Collom
Activity overview
Latest activity by Zachariah Collom-
Zachariah Collom created a post, 2 sided 3D carve tutorial
I am looking for a tutorial for 2 sided 3D carving setup in Carveco. So far I have only been able to find them for other software. I would like to import a large spoon design (.stl) and carve each ...
-
Zachariah Collom created a post, Answeredhow to figure out what g-code line part of your carve is at
I created a carve in Maker, and moved it to my Onefinity running Masso. about 1.5 hours in it stopped and would not recover. I was not able to see what g-code line it was at. Is there a way in Carv...
-
Zachariah Collom commented, Mike, I apricate the help. Unfortunately I am not following. I am using the node editor, have the vector highlighted, hovering over the node and nothing happens when I press any letters on my keybo...
-
Zachariah Collom commented, mike, Thank you for responding. In node editor, if I press "R" I get the relief drop down, as with "I" I get the view drop down. I have been working in node editor and as far as I can tell the node...
-
Zachariah Collom commented, Ok, I tried using the node editor and I found that I have closed shapes. I pulled the green node in the middle down and created this shape: I don't want the lower part, but if I use the trim tool ...
-
Zachariah Collom commented, Basically I want to join these vectors and don't know why I can't. When using the vector doctor i get this: I can't figure out how to fix these intersections. Thank you
-
Zachariah Collom created a post, AnsweredHaving difficulty joining vectors - single line closed vectors
(please also see all added comments below) I imported my design from a dfx. I created the vector, made sure there were no duplicates. I then went to create the tool paths and I of course got many e...
-
Zachariah Collom created a post, AnsweredHow to fix vectors that are too close and or cross each other
I have imported a bitmap into Carveco Maker, used the Bitmap to Vector tool. I tried using the Vector Doctor tool. I went through and deleted all the small vectors that are created. But the problem...
-
Zachariah Collom commented, I could transform the vector yes. I was able to get them all to fillet, i just had to click the vector below. or away from the intersection far enough that the fillet would not cut more than where...
-
Zachariah Collom commented, I think I figured out my issue. I was clicking too close to the tip of the triangle.