Roger Oxford

1. Community
2. Maker & Maker+ Support
3. Vector Selection

I just succeeded in solving the problem of not being able to select a vector by getting a snow flake or a cross bar with a bulls eye in it. After I toggle the visibility of toolpaths off (icon oppo...

• View comment
• Created 20 October 2024 00:36
• 1 vote

1. Community
2. General Discussion
3. Calculating toolpaths and selecting vectors

The last answer assumes you have the initial vectors in view. What to do if the workpiece is blank after simulation reset?

• View comment
• Created 10 October 2023 18:03
• 0 votes