Tom Gustafson
Posts
-
settings for 30 Degree 1/8 inch Shank 0.2mm engraving tip
What tool do I choose and what settings for this engraving tip?
-
Answered
Hole size incorrect?
I am putting a hole in the back of a plaque for a magnet. The magnet is .470" dia by .108" deep. In Carveco Maker, I draw a .470" circle and center it on the work-piece. I choose the Profile toolpa...
-
Answered
How do I create a round hole? .5 in dia .25 in deep
How do I create a round hole in Carveco Maker? .5 in dia .25 in deep. I have imported an .stl of the shape and when I paste it into the model at -.25 Z. It disappears.
-
Answered
Uxcell router bit tool settings?
I have a 1/8" Shank, 30 Degree 0.2mm carbide bit to use for engraving from Uxcell. Where can I find the data base for Uxcell bits? Or what are the settings for this bit. Cutting softwood.
-
Answered
Raster X-Y not clearing surface
I am making a 3D plaque in Carveco Maker. The Finishing pass is Raster X-Y at 45 deg. 1/16" ball mill. Stepover is .0156", Stepdown is .1" , Speed is 30 in/min. When the project completes, there ar...
-
Answered
Area Clearance not clearing the area
I am using a 1/8 end mill to clear an area. When I use the offset tool strategy the path does not clear the entire area. It leaves spots uncut. When I switch to raster, the area is cleared. I am ma...