Tom Gustafson

1. Community
2. Maker & Maker+ Support
3. settings for 30 Degree 1/8 inch Shank 0.2mm engraving tip

Thanks mike. Not a jeweler. I am carving the Harley Davidson plaque into an urn for a friend. The wall is only 5" tall so the model is only 4". At that size my normal 2mm ball will not cut the smal...

• View comment
• Created 21 February 2025 18:00
• 0 votes

1. Community
2. Maker & Maker+ Support
3. settings for 30 Degree 1/8 inch Shank 0.2mm engraving tip

mike, Thanks for the quick response and the link. Can you help me with the bit description in the tools section of Carveco. I am not sure how to enter the measurements. Angle and diameter. Thanks i...

• View comment
• Created 21 February 2025 00:59
• 0 votes

1. Community
2. General Discussion
3. Hole size incorrect?

Here is the transfer link and the screenshot of the project. I have a FoxAlien CNC and am using UGS g-code. https://we.tl/t-bqJj5IM27W When I cut the magnet hole, it is under size and not to depth....

• View comment
• Created 26 July 2024 19:42
• 0 votes

1. Community
2. Community Feedback
3. How do I create a round hole? .5 in dia .25 in deep

Thank you. I finally placed it on the surface and then saved it. .art. Now I can bring it in and place it below the surface. Tom

• View comment
• Created 20 July 2024 20:55
• 0 votes

1. Community
2. Engraving Talk
3. Raster X-Y not clearing surface

Thanks for the quick response. You were correct. The wood is mahogany and very dry. But it was moving. I dropped down .010" and ran the Raster X-Y again. Very light cross hatch pattern over the sur...

• View comment
• Created 16 April 2024 13:03
• 0 votes