Help! Finishing toolpath for relief on Carvera Air - alternately cuts two deep holes at start - does not show on simulation...
Specifically on finishing toolpath using V bit (roughing works fine). Machine cuts one hole near start of toolpath and then cuts another, repeatedly moving between the two and plunging deeper. Has anybody else seen this problem? Is there a setting that I should look at. File size is around 9MB.
I'm not super experienced at CNC and as a first project - pretty simple - this has been challenging.
Comments
Mike,
What, or rather which toolpath are you using? There are quite a few, so it would be great to know which one. Could it be the "Profile"?
mike
Please sign in to leave a comment.