V-Bit Carving issue
Hi,
I'm using Carveco Maker. Does my V-Bit Carving toolpath look ok? My letters look like dog bones and the center didn't carve out at the same depth.
I suspect it is a matter of me saving one of the tools and making an update to another. But wanted to show the following in case I set this up wrong such as limiting depths to 1/8th or something. New to this.
Comments
After pondering more, my guess is that I used my 1/8" End Mill accidentally for my 90 degree V Bit toolpath. SMH.... before I trash this piece, I might plane it .10" or so to see if I get rid of the angles the End Mill caused.
Please sign in to leave a comment.