Luis Barros

1. Community
2. Maker & Maker+ Support
3. Which file extension for Candle

I moved to OpenBuilds controller and works fine, I was able to cut a few projects I had with no issues.

• View comment
• Created 22 October 2022 22:31
• 1 vote

1. Community
2. Maker & Maker+ Support
3. Router bit goes too low when starts cutting (breaking the bits)

Thanks for your answer, saving as UGS did work, but today I was trying to cut a circle with Amana Spiral Plunge bit and started too deep which would break that expensive bit if I didn't stop, is a ...

• View comment
• Created 16 October 2022 19:28
• 1 vote

1. Community
2. Maker & Maker+ Support
3. Router bit goes too low when starts cutting (breaking the bits)

Found my mistake the router bit settings had the stepdown too high

• View comment
• Created 17 October 2022 17:28
• 0 votes