Luis Barros
Activity overview
Latest activity by Luis Barros-
Luis Barros commented, I moved to OpenBuilds controller and works fine, I was able to cut a few projects I had with no issues.
-
Luis Barros created a post, AnsweredWhich file extension for Candle
I was using UGS and I couldn't finish any of my cuts, today I was trying again, just cutting a circle in a 1" thick maple and failed again but this time badly and I almost had a fire in my garage j...
-
Luis Barros created a post, AnsweredDrawing with the polyline but giving the specific measurements
Is possible when we design a shape that's not a square or rectangle to give the measurements we need on each line?
-
Luis Barros commented, Found my mistake the router bit settings had the stepdown too high
-
Luis Barros commented, Thanks for your answer, saving as UGS did work, but today I was trying to cut a circle with Amana Spiral Plunge bit and started too deep which would break that expensive bit if I didn't stop, is a ...
-
Luis Barros created a post, AnsweredRouter bit goes too low when starts cutting (breaking the bits)
I tried a few different designs and always goes too deep, using UGS and saving the files in grlb, I'm new in CNC only lasers and 3d printers before.