Timothy Joy

Timothy Joy created a post, 26 May 2020 16:43
Engraving bits in toolbox
1. Community
2. Engraving Talk
Hi Everyone I'm having a issue adding my engraving bit to the toolbox, not sure where to place them in the toolbox. My bit is a spectool carbide endmill, specs are R1.0*1-1/4'*D1/4'-2F.
- 1 follower
- 0 comments
- 0 votes
Timothy Joy created a post, 18 May 2020 02:11
Engraving bits in toolbox
1. Community
2. Engraving Talk
where or what is the easiest way to add a engraving bit? specs are R1.0 1 1/4 length .250 D 2 flange and a 3.92 degree?
- 1 follower
- 0 comments
- 0 votes
Timothy Joy commented, 08 March 2020 16:00
How do you save a .nc file in stl form, so i can send it into my estlcam to run the stl file for a 3d relief since carveco won't connect to my ardino uno board? One reason i canceled my subscriptio...
- View comment
- Edited 08 March 2020 16:02
- 0 votes
Timothy Joy created a post, 10 February 2020 01:56
Answered

Saving a cnc file
1. Community
2. General Discussion
How do you safe a project as a .nc file that i can put in my UGS?
- 3 followers
- 3 comments
- 0 votes