William Kennedy

1. Community
2. Machining Talk
3. Chamfer with 90 degrees bit

Hi Mike!  Yes, that's kind of what I'm doing.  I make an expanded (or contracted) vector copy ~0.050" away from the edge.  Then set the tool down far enough so it cuts the chamfer. Using 1/2" 90-de...

• View comment
• Created 11 February 2025 01:26
• 0 votes

1. Community
2. Maker & Maker+ Support
3. How to place a relief in a already positioned pocket?

Thanks Mike! I'm not sure that any of that would work for me as the pocket is a vector that gets milled out and is not a relief itself. Anyhow, it's done and looks nothing like the preview, but I...

• View comment
• Created 08 January 2025 00:30
• 0 votes

1. Community
2. Maker & Maker+ Support
3. How to place a relief in a already positioned pocket?

Thanks for the ideas Mike! I'm only using Maker, so I don't think it includes the 'cookie cutter' tool but looks interesting! What I ended up doing was as in the original post, set the relief heigh...

• View comment
• Created 07 January 2025 00:41
• 0 votes