Tony Benson
Comments
-
It is the fact that it tries to finish thin air where the roughing pass has already removed the material that is taking the time. I just wondered if the software took into account the fact that the...
-
Thank you clarifying. I am going to upgrade to Maker+ shortly but the step up to Carveco is a little too steep just yet :-) Kind regards, Tony
-
Thank you for the quick reply. Is that also the same for Maker+ and is there any way of converting stl to rlf?
-
Thank you for the pointer to the video. It is on my to-watch list that one but having the exact spot really helps, much appreciated.
-
I did a test run this evening without ticking the "Multiple Z passes" and it went as expected. Roughed out the excess area and then the finishing tool went straight into the material to finish off....
-
Thanks for the replies. I am probably setting something up in the software wrong. I have just been playing around in the software again and I think if you tick the box "Multiple Z passes" it will t...