Tony Benson
Activity overview
Latest activity by Tony Benson-
Tony Benson commented, Thank you clarifying. I am going to upgrade to Maker+ shortly but the step up to Carveco is a little too steep just yet :-) Kind regards, Tony
-
Tony Benson commented, Thank you for the quick reply. Is that also the same for Maker+ and is there any way of converting stl to rlf?
-
Tony Benson created a post, AnsweredConvert .stl to .rlf
I have a relief model that was designed for me and it is an stl file. It loads into Maker perfectly well as an imported 3D model. Is there any way of getting it converted to a rlf file to make it e...
-
Tony Benson commented, Thank you for the pointer to the video. It is on my to-watch list that one but having the exact spot really helps, much appreciated.
-
Tony Benson commented, I did a test run this evening without ticking the "Multiple Z passes" and it went as expected. Roughed out the excess area and then the finishing tool went straight into the material to finish off....
-
Tony Benson commented, Thanks for the replies. I am probably setting something up in the software wrong. I have just been playing around in the software again and I think if you tick the box "Multiple Z passes" it will t...
-
Tony Benson commented, It is the fact that it tries to finish thin air where the roughing pass has already removed the material that is taking the time. I just wondered if the software took into account the fact that the...
-
Tony Benson created a post, AnsweredRoughing and finishing passes.
I am using Maker and when I carve a relief with a roughing pass using a 6mm tool and then change to a 1/8" ball nose for finishing, the finishing pass travels over the material already removed by t...