Michael Sherve
Comments
-
Is there a difference between them (toolpaths) when you look the tolerance? This could be the place to look.I keep mine at .0001, might be a little snug but it works for me. mike
-
Take a look at a toolpath choose a bit size you will see that you can edit your feed and speed rate for any bit you choose then when you run the toolpath it will run at a different speed. Might I a...
-
Vance, sorry didn't mean to be snarky you can edit the feeds and speeds for the toolpaths in bit selection here's a photo of a quarter inch ball end. mike
-
Odd, my toolpaths in carveco do??? Where are you getting your info? not only this but the router I use also in the control software the ability to over ride suggested speeds and feeds, so if you ...
-
Leighton, What I suggested was for future usage of stl files, I have a lot of them and I have found it's easier to find and bring in clip-art then it is to remember the name of the stl where in c...
-
Tried something new and it worked, esp with my grandchildren I sent out over 200 of these to them, mom and dad said uhh dad their rooms are not big enough............ Oh well. Thanks
-
William, Thanks for the question, must say I never saw this always went to the file I needed to work on then do the work. Man am I glad you asked the question. went to look at it so I checked th...
-
Hi ya Marc. mike
-
Stephen, It's always cool to see what others have dreamed up in using the software, you, I don't think have much to worry about when it comes to people swiping your ideas, Here is something I came ...
-
Which software do you have Carveco, Maker,or Maker plus? I know that my grandchildren love to color Pine when I cut out the models I have made during the year, total fun for them. It teaches them e...