Michael Sherve
Comments
-
Nice Michael, very nice, am very glad my wife didn't see this, I would be out some $$$. mike
-
In the menu bar go over to the word "relief" the last word on that page is "reset", giver er a try mike
-
I missed something like a ton of bricks falling on my head, Tony said "Multiple Z passes" I thought and thought on this and it just bugged the stuffing out of me, when I'm pushing the limit (most o...
-
You didn't say that you were cutting air, how high above the material is it doing this? I am going to assume that you touched off in "Z" for the ball end. When ever I run the 2 mine (the fi...
-
that finish tool (the ballend) will give you a real nice finish, that is the job of the finish pass, it may (as it should) go over the same area as the roughing toolpath, it does this to remove any...
-
Nice. mike
-
Toma, Does your router have a port to take a jump drive? Is it connected to a computer (some are not) I have my design computer in a different location than my router...... When I get a toolpat...
-
Bill, What's he wanting to cut, cut-out?? Sometimes it is faster to line everything up and just let the router do it's work of roughing then finishing if he were to cut out models, if he were cu...
-
Mike that is a good idea, the trouble is sometimes the design can take a day or more then I am blown away at the time it takes, I can only imagine the customer at how that would send them sipping a...
-
I really enjoyed this, Mt Rainer will have to wait (hahahahahaha) I do like a challenge (I think the Mt will be a biggie) but all the sculpting I did I realized HOW bad I would really like some of ...