Michael Sherve
Comments
-
That is very pretty Michael. What software are you using? mike
-
I have done this when I have different models to cut out and I don't want to turn on the vacuum or or I'm running on both ends of the board and nothing in the middle or I want to be careful about b...
-
Ollie, I understand, I do wish when the toolpaths run they would take the most economical moves, but they don't seem to, like when I run a 3d it goes to the furthest point away (really?? is my q...
-
Ollie, Try grabbing the first (top) ones run a toolpath, next do the same with the second (middle) group then do the same with the last (bottom) group. Now when you go to save the toolpaths combi...
-
Not the star the box next to the star
-
Hey Robert, You have an icon (a star) next to that is a blue box with red underneath try clicking that (I never touch those thing, so you might have) that one ICON shuts your 3d off.(I think it'...
-
I don't own a laser, but I would imagine you would not because there would be no friction caused by an end mill. I am coming from what I use in my shop I would run a ball end for indexing and place...
-
Hey Bob, besides being stunned how is everything? Here is a little post to read that might help you https://support.carveco.com/hc/en-gb/community/posts/4404574378129-New-Install I know you don'...
-
4 inch circle is small, how many letters in each circle? How deep do you want the v-bit to go? What is the v-bit, 45%, 60%, 30??? The reason for the choice of Profile toolpath?? Ever think of u...
-
Thank you Michael. mike