Michael Sherve
Comments
-
Jonathon. You could as I have done set your "Z" zero to the top of material set the thickness of your touch pad thicker, touch the "Z" off then run the first finish toolpath, then after that one...
-
Do you mind if I ask "How are you holding the material down?" Wait a minute are you printing these bad boys? or are you cutting them out on a cnc? If it's cnc then my question is very valid. ...
-
Cool, Good luck. Mike
-
Jerrod, Have you been able to do this yet? mike
-
Mike, How large is your model? This will determine what bits you'll need to use. mike
-
Someone asked the same question on the artcam forum, so here's the answer again
-
Mike, Is this what you are after?
-
I'm with Brady on this one and I only use Carveco, There have been times I get overly frustrated with all the steps I have to take to make things, some of those steps add a lot of time, they could ...
-
Did you paste the baby down?? mike
-
Noob, How about getting the diameter of an example (one bit) pasting it here, it isn't really hard to bring in bits so you can add them to your library of bits to use., I will give you step by s...