Michael Sherve
Comments
-
I was thinking while I was doing some sanding, then a (one of those glimmers of intelligence bounced through my space) "why not a sign bar to set up that thing" (used to use those things 45 years a...
-
Perry, Thought about this for a bit. set yourself a plane that's 3 degrees, clamp your part to it, cut your part the sides will be cut at 90 the front will be cut at 3 degrees, just don't cut th...
-
Doc. I did a search for you the first one is the main one. I've ran into the same difficulty can't remember all I had to go through but if I remember right I contacted support and followed their re...
-
Perry, I had some angles to cut that would match up with a dado on a book shelf I think about the same, I didn't have the time to fiddle with it so I just went to the guy that sharpens my saw b...
-
Guillermo, That reallllly sucks, who are they (if you don't mind), I'd hate to purchase from people like that? What's the control software maybe someone has found a way to implement what you nee...
-
Bill, How deep are you going? Hopefully not all the way through. Try outside but go about .035/ .050" deeper then when you cut it out with the end mill you'll be cleaning up the edge. If I remember...
-
Guillermo, Have you contacted the people who sold you your machine yet? Have you found out anything yet? mike
-
Guillermo, Have you tried it yet? I know your machine will jet to some place in outer space if you do such, I have use a techno for over 20 years in my control software I can dictate where I wis...
-
Can I ask for clarification? Mainly, when you make a over whelming large blanketed statement like that one can only have question marks going off in their head. The best way to get help is to be ve...
-
Tim, Thanks for the kind words. I find that Dillon's tactful answers the best and to the point, I kind of wished I had that skill. I do agree with you sometimes the answers would help and sometimes...