Michael Sherve
Comments
-
Mark, Pose your questions, I have the Pro. and I don't mind answering question. I have been using the software for a few days, if I can't give an answer I'll do the research to find it, though a...
-
Now to verify if I was correct, this second pic was after I used the AI, it is not very nice there is a requirement to clean it up, if you have maker or plus I don't think you can. I could be mista...
-
I have been meaning to give (show) what I mean. this first picture is what I did about 10/15 tears ago. It came out really nice and was accepted right away, it's clear the measurement's are what wa...
-
Thank you Anthony. I do like Carveco, been using it for a few days so I'm adapt at doing just about anything that comes to my head, especially if I like the subject. This year I did about 5 ghost...
-
Jerry, You can give it a try, but I'm thinking you will need to use the 2 rail sweep, the shape editor, and possibly the angled plane tools, at least to get a nice model. The picture isn't ver...
-
Does your router have stepper motors , do you have ball screws for movement or do you have little cogs that use a set screw to hold it in place, was your bit tight in the collet, what was your step...
-
I have been rather busy, in the last few month I've had a lot of holiday models to make 2 weeks ago I got an order for 3 lions 3 sheep and 4 different lambs with specific pose's, yesterday I sent a...
-
Ashwind, This is what it would look like if you were to tilt inside vector so it touched the outside vector an use the "Explode vector tool" mike
-
Elina, I think he has Maker, I don't think that has the Polyline tool. He hasn't stated which verity of Carveco he's work in, might help. I suggested he look on line for a single line font that ...
-
Ashwind, To make vectors inside other vectors all you have to do is make the shape using tools give, again in the Pro, I know there are restriction in Maker and Maker Plus so this is why I stat...