Michael L Prestigiacomo

New at this going to need lots of help

Total activity 26
Last activity 13 October 2022 14:01
Member since 03 March 2021 20:11

Following 0 users
Followed by 0 users
Votes 10
Subscriptions 3

Comments

Recent activity by Michael L Prestigiacomo

Mike I contacted Mach3 support and was told that " Hello, You're missing steps on your axis tuning. Best Regards,Trevor"
- View comment
- Created 05 March 2021 15:18
- 0 votes
Thank you I sent them Email
- View comment
- Created 03 March 2021 20:59
- 1 vote
Sorry. How do i attach files ?
- View comment
- Created 03 March 2021 20:50
- 1 vote
I use a 24000 80mm spindle wired directly to the VFD (No belts). Steppers are wired directly into the controller. I would think pretty stable connections
- View comment
- Created 07 March 2021 17:47
- 0 votes
I did everything that they told me. Re tuning the motors as suggested. The machine runs smoother but I still have oblong circles. It is odd because I cut out a heart and it was perfect. I would thi...
- View comment
- Created 07 March 2021 14:49
- 0 votes
I am so tired of going over that manual. It is like groundhog day
- View comment
- Created 06 March 2021 00:07
- 0 votes
As you mentioned earlier. This is a Chinese machine . I do not speak Chinese so getting answers from them is out of the question. This is a mistake that I will not ever make again. If you are famil...
- View comment
- Created 05 March 2021 13:41
- 0 votes
Mike I am just getting this thing up and running. So no I have not
- View comment
- Created 05 March 2021 13:37
- 0 votes
To make it even harder my machine uses USB to talk to the controller. If it were a parallel port it would do most of the set up automatically
- View comment
- Created 04 March 2021 19:54
- 0 votes
Thanks again for the tip. I am using a Chinese machine " Lead CNC Bulk Man 3D" I am not sure what post processor to use . So far I am using Mach3_4(inch) *.tap. Any suggestions ? Mike
- View comment
- Created 04 March 2021 13:35
- 0 votes