Avatar

Barry Goodman

My wife and I have been jewelers for about 45 years and I have been using AC since 2005.

  • Total activity 343
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 3
  • Subscriptions 105
Follow

Comments

Recent activity by Barry Goodman
Sort by recent activity Recent activity Votes
    1. Community
    2. Jewellery Making Talk
    3. photo or movie

    Hi Evonne, as I said all you have to do is is  click on the "View" menu then click on "Save 3D View Image", and you can save a pic of the model as it appears in the 3D view. I have a copy of 9.1 on...

    1. Community
    2. Jewellery Making Talk
    3. photo or movie

    Mike, you do not need a 3rd party program for 3D views (photos) of the model, all you have to do is is go to, View>Save 3D View Image, and you can save a pic of the model as a reg picture (bmp, jpg...

    1. Community
    2. Jewellery Making Talk
    3. photo or movie

    Are you talking about the model as it looks in Carveco 3D view or a finished looking piece of jewellery?

    1. Community
    2. General Discussion
    3. Hello All

    There clearly are more active members here than I thought, glad to see you guys here and helping out. I thought it was essentially Mike and myself.

    1. Community
    2. General Discussion
    3. Hello All

    Hi again Jimmy, Have you asked for help directly from support or just on the forum? I have never used nesting but there are those who use it all the time. Too bad this forum is so lacking in active...

    1. Community
    2. Machining Talk
    3. Multicam 3000

    With Craveco you can install the program on 2 PCs at the same time so this would be good for you in this regard. I gather that you have a license for AC so I thought I would mention the following. ...

    1. Community
    2. Machining Talk
    3. Multicam 3000

    If you are evaluating the program and having problems with it you might want to deal with support directly. This forum is not as well populated as would be ideal yet so you might get faster results...

    1. Community
    2. Gallery
    3. Jewellery

    Very well done, thanks for sharing all the different pics.

    1. Community
    2. Community Feedback
    3. compatibility question

    Hi Sam, the software is not the issue, its the g-code. This has not changed so you should be OK. I have a MM mill that still has the Foredom motor (the mill is over 10 years old) and it works just ...

    1. Community
    2. Feature Discussion
    3. tool icon list

    Here (pic attached) are the tools available in New Project. You do not have these tools in New Model. As I said jewelers would use New Project to do rings and bangles but others could use it to mak...