Barry Goodman

1. Community
2. General Discussion
3. Intarsia

Very very nice work.Congrads. I do not have maker so I cannot provide guidance specific to that version of the software but you should, I would think, have no problem doing what you are describing ...

• View comment
• Created 13 March 2020 08:01
• 0 votes

1. Community
2. Maker & Maker+ Support
3. recent problem after latest update

I would try to uninstall the program and then reinstall it. You are not doing anything wrong, it sounds like a corrupt installation.

• View comment
• Created 13 March 2020 02:55
• 0 votes

1. Community
2. General Discussion
3. consistent perimeter edge

Hi Bill, I would suggest that you define a vector a bit inside of your outside perimeter vector and then select both vectors and run an "Offset (classic)" tool-path inside these selected vectors. T...

• View comment
• Edited 21 February 2020 19:25
• 0 votes

1. Community
2. Feature Discussion
3. Technique video page

I just spent some time looking at the videos on the you tube page and I must say they are much better than the ones provided by DelCam. It is much easier to follow what is happening and why. Well d...

• View comment
• Created 16 February 2020 04:12
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

You are most welcome. I hope the above has helped.

• View comment
• Created 11 February 2020 07:36
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

Gary, I did some significant editing to my post above, you may want to re-read it as you posted while I was editing.

• View comment
• Edited 11 February 2020 00:56
• 0 votes

1. Community
2. General Discussion
3. Question about relief creation differences in the different past versions of ArtCam

Gary, I have been using ArtCAM since version 7 and I find most of the combine modes to be of no value to me. I use merge high and add and very occasionally, subtract, but that's it. Everybody uses ...

• View comment
• Edited 11 February 2020 01:09
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

That is correct Gary.

• View comment
• Created 07 February 2020 18:46
• 0 votes

1. Community
2. General Discussion
3. Zero Rest

Select the vector and hit either ctrl+0 or ctrl+alt+0 (just in case of confusion, the + sign is not included in the hot key). There are icons available for these 2 commands if you prefer using icon...

• View comment
• Created 07 February 2020 03:57
• 0 votes

1. Community
2. Engraving Talk
3. Does Carveco support Roland Engravers?

Mark, you might want to ask support directly about this. Go to the top of the page and on the right you will see a link that says Submit a Request. That's the one you want. You may have to wait a b...

• View comment
• Created 05 February 2020 02:33
• 0 votes