Chris Johnson

1. Community
2. Maker & Maker+ Support
3. Final pass when profiling

Michael Sherve Thanks for this. I was anticipating you were going to say this. I was just trying to determine if there was a way with using the system configured toolpath or if I was going to have ...

• View comment
• Created 13 November 2024 18:03
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Adding a pause

I currently have the following setup: Machine: Onefinity Elite with Masso controllerPost processor: Onefinity Elite (inch)

• View comment
• Created 21 August 2024 12:57
• 0 votes