Avatar

Chris Johnson

  • Total activity 6
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 2
Follow

Activity overview

Latest activity by Chris Johnson
  • Chris Johnson commented,
    1. Community
    2. Maker & Maker+ Support
    3. Final pass when profiling

    Michael Sherve Thanks for this. I was anticipating you were going to say this. I was just trying to determine if there was a way with using the system configured toolpath or if I was going to have ...

  • Chris Johnson created a post,
    Answered

    Final pass when profiling

    1. Community
    2. Maker & Maker+ Support

    When setting up the Profiling toolpath in Carveco Maker, is there a way to switch bits between the roughing pass and the final pass? I would like to use an upcut bit when roughing and then use a co...

    • Edited
    • 2 followers
    • 3 comments
    • 0 votes
  • Chris Johnson commented,
    1. Community
    2. Maker & Maker+ Support
    3. Adding a pause

    I currently have the following setup: Machine: Onefinity Elite with Masso controllerPost processor: Onefinity Elite (inch)

  • Chris Johnson created a post,
    Answered

    Adding a pause

    1. Community
    2. Maker & Maker+ Support

    I am new to Carveco Maker and CNC, so apologies if this seems like an odd question. One of the things I would like to do is add a pause between 'layers.' As an example, I use a z dependent dust boo...

    • 2 followers
    • 2 comments
    • 0 votes