Darin Murphy

1. Community
2. Maker & Maker+ Support
3. Every toolpath saved has a starting point offset in both X and Y

Update on this issue and a request for closure.  I sent CarveCo another file, since the one they were requesting was no longer available.  Needless to say they believe the issue was with either the...

• View comment
• Created 07 July 2023 01:00
• 1 vote

1. Community
2. Maker & Maker+ Support
3. Every toolpath saved has a starting point offset in both X and Y

I'm sorry, but if you don't mind me asking, did you read my last message? I stated the following: "I only used UGS to illustrate how off the toolpath was, even though CarveCo shows everything as no...

• View comment
• Edited 30 June 2023 01:40
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Every toolpath saved has a starting point offset in both X and Y

Additionally, I had added a screen shot of the Set Position, which is defaults to having "Choose at cursor" so I removed it because I didn't want anyone reading this to get the idea that I selected...

• View comment
• Edited 28 June 2023 18:45
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Every toolpath saved has a starting point offset in both X and Y

Thank you for your quick assistance to the issue I am having.  I am including some additional screen shots to show what size I have the size is set at, as well as the code of the surface planning t...

• View comment
• Edited 28 June 2023 18:39
• 0 votes