Beau James

1. Community
2. Maker & Maker+ Support
3. Surfacing multiple project boards.

Thanks for taking this on and sharing the end results! If you are unaware, I’m in a maker community called “CNC with Me” which was created by @Hamilton Dilbeck who I follow on YouTube as well. Up t...

• View comment
• Created 02 March 2024 12:50
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Surfacing multiple project boards.

I think that’s the ticket. Probe from the waste board and not the material surface. This was you ALWAYS finish at .5” as opposed to probing z on the top of the Material where it would take .5 off w...

• View comment
• Created 29 February 2024 05:04
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Surfacing multiple project boards.

Lamar, no official resolution at this time. I’ve been wrapped up with other things lately. But I’ll be reaching out to CarveCo direct if I can’t figure it out after my next batch of surfacing.

• View comment
• Created 27 February 2024 23:14
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Surfacing multiple project boards.

I have not physically attempted that. But I believe it would work providing I make the material thickness slightly above the thickest piece that I have. I would lose some efficiently for the boards...

• View comment
• Created 06 December 2023 11:39
• 0 votes

1. Community
2. Maker & Maker+ Support
3. Surfacing multiple project boards.

Thanks, Lamar. Same here. Best wishes.

• View comment
• Created 28 February 2024 00:55
• -1 votes