Beau James

Total activity 7
Last activity 02 March 2024 12:50
Member since 05 December 2023 00:03

Following 0 users
Followed by 0 users
Votes 0
Subscriptions 1

Beau James commented, 02 March 2024 12:50
Thanks for taking this on and sharing the end results! If you are unaware, I’m in a maker community called “CNC with Me” which was created by @Hamilton Dilbeck who I follow on YouTube as well. Up t...
- View comment
- 0 votes
Beau James commented, 29 February 2024 05:04
I think that’s the ticket. Probe from the waste board and not the material surface. This was you ALWAYS finish at .5” as opposed to probing z on the top of the Material where it would take .5 off w...
- View comment
- 0 votes
Beau James commented, 28 February 2024 00:55
Thanks, Lamar. Same here. Best wishes.
- View comment
- -1 votes
Beau James commented, 27 February 2024 23:14
Lamar, no official resolution at this time. I’ve been wrapped up with other things lately. But I’ll be reaching out to CarveCo direct if I can’t figure it out after my next batch of surfacing.
- View comment
- 0 votes
Beau James commented, 06 December 2023 11:39
I have not physically attempted that. But I believe it would work providing I make the material thickness slightly above the thickest piece that I have. I would lose some efficiently for the boards...
- View comment
- 0 votes
Beau James created a post, 05 December 2023 00:03
Answered

Surfacing multiple project boards.
1. Community
2. Maker & Maker+ Support
I have multiple pieces of hard maple ranging from 1.1 to 1.375 inches thick. I’m trying to surface each of them to 1” before I cut my trays. Question: How do I set up this tool path to z-zero fro...
- 3 followers
- 11 comments
- 0 votes