post processor problem
Hi
I am having a problem, it appears that when I enter a vbit for a toolpath the post possessor is changing the feed rat from inches to seconds I have been in conversation with shopbot support and this was their response after I shared my cut file with them. It is only doing this with my Vbit selection. I have a screen shot of my tool selection and cut file attached. I haven't had this problem before, just as a note I did just do the latest update
Bill
Comments
Hi Bill,
Your post has been escalated to a support request by Carveco Support; your ticket number is 1767. Please check the inbox associated with your registered email address. Thanks in advance for your time and cooperation.
Hi
Finally had a chance to get back to the shop and examine those tools, they were set to inch seconds in the setup page never had an issue with my other machine which runs Mach 3. With my new shopbot their post processors creates a problem.
live and learn stay healthy
Bill
Please sign in to leave a comment.