Answered
Saving Toolpaths
I own a bobscnc and use universal gcode sender with GRBL..What do i save the the tooldpath to use on these?
Comments
This topic is for discussing new features in Carveco software only; it is not intended for asking general questions about using Carveco software.
The following area was created specifically for requesting assistance with using the Carveco Maker and Carveco Maker+ products: Maker & Maker+ Support
The following area is intended for general questions relating to Carveco software: General Discussion
A support request has been created from your post, and the ticket number is 1580. You should expect to receive an email from Carveco Support on this subject.
Post is closed for comments.