If you draw straight lines then the transform tool will give you the length of that if you make an oval it'll give you the surface area that's covered if you look down to the lower right you will be given the same.
Kind of sucks a little that the moment you start to contort it you will not be given the length of the line only the surface area covered though.
Am wondering why you would need this, you're not running wire are you? Wouldn't mind somethings added if I could understand the need.
I would like some things added to the modeling area that I think would be great also, but I have receive a big negative (at-least that's the way I understood it) but this hasn't stopped me from liking and using the software.
Comments
If you draw straight lines then the transform tool will give you the length of that if you make an oval it'll give you the surface area that's covered if you look down to the lower right you will be given the same.
Kind of sucks a little that the moment you start to contort it you will not be given the length of the line only the surface area covered though.
Am wondering why you would need this, you're not running wire are you? Wouldn't mind somethings added if I could understand the need.
I would like some things added to the modeling area that I think would be great also, but I have receive a big negative (at-least that's the way I understood it) but this hasn't stopped me from liking and using the software.
mike
Please sign in to leave a comment.